POWER LED HEAD BULB Genuine HID→LED

10,000 lumens of brightness that exceeds HID!
Easily exchange from HID to LED!

Achieves approximately 1.6 times the brightness compared to genuine HID. *Right and left total 10,000 lumens.
Can be attached to the genuine ballast connector with a coupler on.
Excellent heat dissipation design maintains initial brightness.

• Compatible with vehicle inspection
• For head valve only
• 3 year warranty
• Color temperature 6500K
• coupler on
• rear fan
• High luminous flux maintenance rate
• Integrated driver
• Brightness
  10000 lumens

Easy to install! Replace the genuine HID bulb with an LED head bulb!

Just connect it to the visibility HID ballast connector and it will turn on.
*It can only be used for car with projector lamps. Not applicable to R type.
*Please refer to the compatibility table for vehicle model application.

Equipped with the strongest cooling mechanism! Copper board + heat pipe + rear cooling fan

Brightness is 5000lm (lumens) on one side with zero attenuation from initial lighting.
The LED light emitting part lights up while generating a considerable amount of heat. In order to immediately transfer the heat generated by the light emitting part to the rear, the triple layer structure of a copper substrate with excellent thermal conductivity, a heat pipe with excellent heat transfer, and an ultra-cooling heat sink fan achieves the strongest temperature control! Although it has a large amount of light, there is no heat sag (attenuation) from the initial lighting!
★"Momentary point" LED stabilizes to MAX brightness in about 0.5 seconds! *HID takes 20 seconds or more for the brightness and color to stabilize. (See graph of brightness and lighting time)

10,000lm (lumens) brighter than genuine HID, 1.6 times brighter

Approximately 1.6 times the brightness and visibility compared to normal HID bulbs.
Genuine HID replacement LED head bulb with the highest brightness! 10000 lumens! *Value for 2 pieces for 1 unit.
The originally bright HID bulb has been commercialized with greatly improved visibility and practicality. By using it exclusively for projector lamps, we have achieved highly accurate light distribution.

Even a light intensity tester makes a difference.

By using it exclusively for projector lamps, we have achieved highly accurate light distribution, making it compatible with vehicle inspections and greatly increasing the brightness of the irradiation surface.
For cars that are difficult to see or dark even with HID, you can expect a significant increase in the brightness tester.
*Not compatible with all vehicles. Please be sure to refer to the compatibility table for each vehicle type.

Rubber cover available as mounting option

For vehicles that cannot accommodate the ballast connector inside the light fixture, we offer a rubber cover that can be attached in place of the resin cover at the rear of the genuine light fixture.
Two types: 90mm and 95mm outside diameter. Please be sure to refer to the compatibility table for each vehicle type for application.